Configuring Link Bundles
Step 22
Repeat Step 19 through Step 21 to add more Ethernet interfaces to the bundle you created in Step 2 .
Step 23
Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Step 24
Perform Step 1 through Step 23 on the remote end of the connection.
Brings up the other end of the link bundle.
Step 25
show bundle Bundle-Ether bundle-id [ reasons ]
Example:
RP/0/RSP0/CPU0:router#show bundle Bundle-Ether 3 reasons
(Optional) Shows information about the specified Ethernet link bundle.
The show bundle Bundle-Ether command displays information about the specified bundle. If your bundle has been
configured properly and is carrying traffic, the State field in the show bundle Bundle-Ether command output will
show the number "4," which means the specified VLAN bundle port is "distributing."
Step 26
show ethernet trunk bundle-Ether instance
Example:
RP/0/RSP0/CPU0:router# show ethernet trunk bundle-ether 5
(Optional) Displays the interface configuration.
The Ethernet bundle instance range is from 1 through 65535.
Configuration Examples for Link Bundles
EtherChannel Bundle running LACP: Example
This example shows how to join two ports to form an EtherChannel bundle running LACP:
RP/0/RSP0/CPU0:Router# config
RP/0/RSP0/CPU0:Router(config)# interface Bundle-Ether 3
RP/0/RSP0/CPU0:Router(config-if)# ipv4 address 1.2.3.4/24
RP/0/RSP0/CPU0:Router(config-if)# bundle minimum-active bandwidth 620000
RP/0/RSP0/CPU0:Router(config-if)# bundle minimum-active links 1
RP/0/RSP0/CPU0:Router(config-if)# exit
RP/0/RSP0/CPU0:Router(config)# interface TenGigE 0/3/0/0
RP/0/RSP0/CPU0:Router(config-if)# bundle id 3 mode active
RP/0/RSP0/CPU0:Router(config-if)# no shutdown
RP/0/RSP0/CPU0:Router(config)# exit
RP/0/RSP0/CPU0:Router(config)# interface TenGigE 0/3/0/1
RP/0/RSP0/CPU0:Router(config-if)# bundle id 3 mode active
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
Configuration Examples for Link Bundles
67