Configuring Erp Parameters - Cisco ASR 9000 Series Configuration Manuallines

Implementing Multipoint Layer 2 Services
RP/0/RSP0/CPU0:router(config-l2vpn-erp-instance)# inclusion-list vlan-ids e-g
Associates a set of VLAN IDs with the current instance.
Step 15
aps-channel
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-erp-instance)# aps-channel
Enters the Ethernet ring G.8032 instance aps-channel configuration submode.
Step 16 level number
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-erp-instance-aps)# level 5
Specifies the APS message level. The range is from 0 to 7.
Step 17
port0 interface type path-id
Example:
RP/0/RSP0/CPU0:router(configl2vpn-erp-instance-aps)# port0 interface GigabitEthernet 0/0/0/0.1
Associates G.8032 APS channel interface to port0.
Step 18 port1 { interface type interface-path-id | bridge-domain bridge-domain-name | xconnect xconnect-name | none
}
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-erp-instance-aps)# port1 interface GigabitEthernet 0/0/0/1.1
Associates G.8032 APS channel interface to port1.
Step 19 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.

Configuring ERP Parameters

Perform this task to configure ERP parameters.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
Configuring ERP Parameters
283