Cisco ASR 9000 Series Configuration Manuallines page 191

Implementing Point to Point Layer 2 Services
Enters the Global Configuration mode.
Step 2
l2vpn
Example:
RP/0/RSP0/CPU0:router (config)# l2vpn
Enters Layer 2 VPN configuration mode.
Step 3 xconnect groupgroup-name
Example:
RP/0/RSP0/CPU0:router (config-l2vpn)# xconnect group span
Configures the cross-connect group.
Step 4
p2p xconnect-name
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-xc)# p2p span-foo
Configures the point-to-point cross-connect.
Step 5 monitor-session session-name
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p)# monitor-session customer-foo
Specifies the monitor session.
Step 6
neighbor ipv6 peer-address pw-id pseudowire-id
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p)# neighbor ipv6 1111:3333::cdef pw-id 1001
Specifies the peer with which to cross connect, and configures the pseudowire segment for the cross-connect.
Step 7 pw-class class-name
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p-pw)# pw-class ts
Enters pseudowire class submode, and allows a pseudowire class template definition.
Step 8
sourcepw-source-address
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
Configuring Traffic Mirroring over L2TPv3 over IPv6 Tunnels
165