Configuring The Optical Parameters - Cisco 6000 Series Configuration Manual

Configuring Dense Wavelength Division Multiplexing Controllers
Note All interface configuration tasks for Gigabit Ethernet interfaces still must be performed in interface configuration
mode.

Configuring the Optical Parameters

This task describes how to configure the wavelength parameters for the DWDM controller to set the operational
wavelength of a tunable SFP+ module. The DWDM controllers are configured in the physical layer control
element of the Cisco IOS XR software configuration space.
SUMMARY STEPS
1. configure
2. controller dwdm interface-path-id
3. admin-state out-of-service
4. commit
5. wavelength channel-number
6. commit
7. admin-state in-service
8. Do one of the following:
9. show controllers dwdm interface-path-id optics
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2 controller dwdm interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# controller dwdm
0/1/0/0
Example:
RP/0/RP0/CPU0:router(config-dwdm)#
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
• end
•
• commit
Configuring the Optical Parameters
Purpose
Enter the XR Config mode.
Specifies the DWDM controller name in the notation
rack/slot/module/port and enters DWDM configuration
mode.
131