Configuring An Access Pseudowire Using Evpn-Vpws - Cisco ASR 9000 Series Configuration Manuallines

Configuring an Access Pseudowire using EVPN-VPWS

Step 5
p2p xconnect-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p pw-ss
Enters P2P configuration submode.
Step 6 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface gigabitethernet 0/1/0/9
Specifies the interface type and instance.
Step 7
neighbor evpn evi vpn-idtarget ac-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor evpn evi 100 target 12
Enables EVPN-VPWS endpoint on the p2p cross-connect.
Step 8 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring an Access Pseudowire using EVPN-VPWS
Bridge-domain can configure an access pseudowire using EVPN-VPWS:
SUMMARY STEPS
1. configure
2. interface type interface-path-id
3. l2vpn
4. bridge group bridge-group-name
5. bridge-domain bridge-domain-name
6. neighbor evpn evi vpn-id target ac-id
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
180
Implementing Point to Point Layer 2 Services