H-Vpls Configuration: Examples; Vpls With Qinq Or Qinany: Example - Cisco CRS Configuration Manual

H-VPLS Configuration: Examples

end
H-VPLS Configuration: Examples
This example shows how to configure hierarchical VPLS (H-VPLS). All examples in this section are based
on the following topology where N-PE1 is the H-VPLS Node:

VPLS with QinQ or QinAny: Example

Global Interface Configuration at N-PE1:
interface GigabitEthernet0/0/0/0
dot1q tunneling ethertype 0x9200
!
interface GigabitEthernet0/0/0/1
dot1q tunneling ethertype 0x9100
!
interface GigabitEthernet0/0/0/0.1 l2transport
encapsulation dot1q 20 second-dot1q 21
!
interface GigabitEthernet0/0/0/1.1 l2transport
encapsulation dot1q 10 second-dot1q any
L2VPN Configuration at N-PE1:
l2vpn
bridge group g1
bridge-domain d1
interface GigabitEthernet0/0/0/0.1
!
interface GigabitEthernet0/0/0/1.1
!
vfi core-pws
Global Interface Configuration at N-PE2:
interface GigabitEthernet0/6/0/0
dot1q tunneling ethertype 0x9200
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
120
port-down flush disable
neighbor 6.6.6.6 pw-id 10
Implementing Multipoint Layer 2 Services