ETC SmartFade User Manual page 37

RATE and Sequences
Adjust sequence fade rates:
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
Adjust sequence step times (chase rate):
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
2
Normal Mode
Press the [MEMS] button. Faders with recorded sequences, 21-24 (45-48), light
yellow.
Press [RATE] once. Faders with recorded sequences, 21-24 (45-48) will blink at
full yellow.
Press the bump button corresponding to the sequence you want to adjust. The
LCD shows the selected sequence fader number, the step number, the recorded
fade times and the step's contents (given as memory page/number).
Press and hold [RATE]. This will display the fade rate percentage.
Turn the dial to adjust the fade times proportionally in a range of 0% (instant) to
999% (10x slower than the recorded times.) for all steps on the selected
sequence. The rate is stored as an override to the recorded timing.
You may press [RATE] again to view levels in the LCD window. The rate override
will remain in place.
To remove the fade rate override repeat the process above, turning the dial until
100% is displayed.
Press [MEMS]. Faders with recorded sequences, 21-24 (45-48), light yellow.
Press [RATE]. Faders with recorded sequences, 21-24 (45-48) will blink at full
yellow.
Press the bump button corresponding to the sequence you want to adjust. The
LCD shows the selected sequence fader number, the step number, the recorded
fade times and the step's contents (given as memory page/number).
Turn the dial to alter the displayed step times proportionally in a range of 999%
(10x faster than recorded step time) to 0% (stopped). The rate is stored as an
override to the recorded timing.
You may press [RATE] again to view levels in the LCD window. The rate override
will remain in place.
To remove the step rate override repeat the process above, turning the dial until
100% is displayed.
33