Next Mode And The Stack - ETC SmartFade User Manual

Jump to a step number:
Step 1:
Step 2:
Step 3:
Step 4:
N E X T M o d e a n d t h e S T A C K
You can also play back the stack in NEXT Mode. This allows you to supplement the
recorded steps in the stack with additional channels that you may add, in blind, before
playing the step. The added channels will accompany the recorded step and will follow the
same fade times set in the stack.
Play back the stack in NEXT Mode:
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
30
Press and hold [STACK].
Use the dial to select the desired step number in the LCD window.
Release [STACK]. The selected step is now pending in the crossfaders.
Press [ .. ] to fade into the selected step.
Press a channel range button [1-24] or [25-48] (or [1-48] and [49-96]).
Press [STACK]. The console enters STACK Mode and shows the next available
step (Stp 1) in the LCD window.
Press [NEXT]. The NEXT button illuminates and the bumps of any channels
included in the next step will light.
Set any additional channel levels using faders 1-24 (or 1-48). Use the channel
range buttons, [1-24] and [25-48] (or [1-48] and [49-96]), to access channels as
needed.
Press [ .. ] to fade into the next step automatically. The step will fade in
according to the time set during programming. Any added levels will fade in with
the pre-programmed step.
Repeat steps 4-5, as needed, as you play through the stack.
SmartFade v1.6 User Manual