Snapshot - ETC SmartFade User Manual

S N A P S H O T
SmartFade provides ten snapshot locations for lighting looks that you want to record, but
you may not know which memory location you want to use. Each time you record a
snapshot, it is stored in the next available snapshot number. If you have ten snapshots
recorded and you record an eleventh, the contents of snapshot #1 are overwritten with the
new levels. The contents of snapshots can be copied to a memory location using the LCD
menu.
N o t e :
Snapshots cannot be played back until they have been recorded to a memory. You can
view a snapshot using the "View and Copy Snap" menu (see
page
Record to a snapshot location:
At any time, press [SNAPSHOT]. The button blinks momentarily and the LCD shows a
message indicating the snapshot number recorded. The [SNAPSHOT] button lights as
follows:
Snapshots are not lost when the console is turned off. When you cycle power on the
console and snapshots are recorded, the [SNAPSHOT] button will be lit and the first
snapshot recorded after the power-up will record to the next higher snapshot number from
the last one recorded in the previous session. To copy the contents of previously recorded
snapshots, use the LCD menu. See
C A U T I O N :
36
38).
• Off . . . . . . . . . . . . . No snapshots are recorded.
• On red . . . . . . . . . . One or more snapshots have been recorded.
Pressing [CLEAR] and [SNAPSHOT] will erase all recorded snapshots.
Normal Mode LCD Menu, page
Normal Mode LCD Menu,
38.
SmartFade v1.6 User Manual