Playback Memories - ETC SmartFade User Manual

Step 5:
Step 6:
Step 7:
N o t e :
If memory faders are at different levels than the current output for that memory, the
bumps will blink dim red. Move the fader to the current memory output level and the bump
will change to steady full red.
P l a y b a c k M e m o r i e s
After you have recorded memories, you will want to reproduce them.
View recorded memories:
Step 1:
Step 2:
Clear active memories:
Step 1:
N o t e :
Pressing [CLEAR] will not erase any memory data.
2
Normal Mode
Press the bump button of the memory you want to edit. The console will
temporarily enter channel mode and the faders will default to the first range of
available channels. Press the channel range button for the second half of the
available channels if needed. The bump buttons will light to indicate the recorded
channels/levels in the selected memory.
Adjust channel faders as needed. You may need to raise the fader above the
current channel output. Previously recorded levels must be brought to full and
then decreased to alter them. The bump buttons of adjusted channels will
brighten/dim to indicate a change has been made.
Press [EDIT MEM]. The modifications are stored to the selected memory and the
console returns to the previous fader mode.
Press [MEMS] to playback memories manually.Memory bumps will light as
follows:
• Dim Red . . . . . . . . . Recorded memory at level zero
• Full Red . . . . . . . . . Recorded memory at any level above zero.
• Unlit . . . . . . . . . . . . Empty memory slot
Move the corresponding fader to activate the desired memory or press the
memory's bump button to view the memory at full.
Press [CLEAR] [CLEAR] [CLEAR] to clear all active memory output from the
console.
21