ETC SmartFade User Manual page 29

Step 8:
Step 9:
Step 10: When a suitable sequence is generated, press [REC SEQ] to complete
N o t e :
Sequences recorded with MAGIC are stored and may be edited just as with normal
sequences.
Use [CLEAR] to cancel recording in [REC SEQ]:
Press [CLEAR] to cancel recording. The console reverts back to whatever fader mode it
was in before the [REC SEQ] button was pressed.
Use [UNDO] to revert to the previously recorded sequence:
If you record a sequence to the incorrect location, press [UNDO] immediately. The previous
sequence, if any, will be restored.
Edit a sequence:
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
2
Normal Mode
You can alter any of the parameters offered in the LCD window. Press [ ] to
move from one parameter to the next. The parameters in the LCD are:
• Order . . . . . . . . . . . 100% means that there is no randomization, constant
• Fade . . . . . . . . . . . . The fade time, adjustable from 0 to 59.9 seconds in 0.1
• Rate . . . . . . . . . . . . The step time, adjustable from 0 to 59.9 seconds in 0.1
If you change the included memories or channels, press [MAGIC] again to view
the changes.
recording.
Press [ ] to enter the menu.
Turn the dial until "Sequences" appears in the window. Press [ ].
Turn the dial to choose which sequence to alter. Choices are 21-24 (45-48) or
"XF" which represents the stack.
Use [ ] and the dial to navigate to Modify Steps>Select Step>Edit.
Press [ ] again. EDIT MEM begins to flash and the console switches to channel
range mode.
Adjust the faders as needed to achieve the desired look.
Press [EDIT MEM]. The sequence step has now been updated.
times are used during playback. 50% means that the
times are randomized between half and full scale of the
displayed times. 0% means that the times are fully
randomized between zero and the displayed fade and
rate times.
second increments.
second increments.
25