Copy Memories And Sequences - ETC SmartFade User Manual

C o p y M e m o r i e s a n d S e q u e n c e s
[COPY] allows memories to be copied from any fader on any page to any other fader on
any other page. Sequences can also be copied to and from faders 21-24 (45-48).
Copy a memory or sequence:
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
26
Press [COPY]. [COPY] lights full white and the console enters Memory mode.
Bump buttons on faders 1-24 light as follows:
• Unlit . . . . . . . . . . . . Empty memory.
• Blink full red . . . . . . Occupied memory with content to be copied from.
• Blink full yellow. . . . Occupied sequence with content to be copied from.
If needed, press and hold the [MEMS] button, then press the bump button (1-12)
corresponding to the page you want to load.
Press the bump button corresponding to the memory or sequence you want to
copy from (the source memory/sequence). The bump buttons will light as follows:
• Off . . . . . . . . . . . . . Unavailable to record. This will only appear on memory
• Blink full red . . . . . . Memory is empty and available.
• Blink dim red . . . . . Memory is recorded. Contents will be overwritten.
• Blink full yellow. . . . Sequence is empty and available.
• Blink dim yellow . . . Sequence is recorded and will be overwritten.
If needed, press and hold the [MEMS] button, then press the bump button (1-12)
corresponding to the page you want to load.
Press the bump button corresponding to the memory or sequence you want to
copy to (the target memory/sequence). The copy is completed, the [COPY]
button goes out, and the console is returned to the previous fader mode.
01/01 if it has been set to master DMX Input.
SmartFade v1.6 User Manual