ETC SmartFade User Manual page 28

Step 6:
Step 7:
Step 8:
Record a Magic sequence:
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
24
Press:
• the bump button of the memory you want to insert as the first step. Then
press the bump button for the memory you want to insert as the next step.
Repeat for as many steps as needed, up to 24 for a sequence fader. You can
change the memory page as needed as you record the steps.
• the channel range button corresponding to the channel you want to insert
into a step. Individual channels can be inserted as sequence steps.
• and hold the bump button of the first memory or channel in a range, then
press the bump button for the last memory or channel in a range. Memories
or channels will be entered one per step for the number of memories or
channels selected. The running order is based on whether the starting
memory/channel number is higher or lower than the end memory or channel.
Ranges may only be selected on the same page.
• You can use any of the above methods in any combination in any sequence.
If you enter more steps than are allowed, a warning message will appear on
the LCD window.
When the sequence is complete, press [REC SEQ]. The faders remain in
whatever mode they were last in.
To take control of the sequence, press [MEMS] to enter Memory mode and move
the fader up from the bottom of travel to start the sequence.
Press [MEMS] to enter memory mode. If needed, press and hold the [MEMS]
button, then press the bump button (1-12) corresponding to the page you want
to load.
Press [REC SEQ] and then press bump 21-24 (45-48) to select the desired
sequence fader.
Bring the fader for the selected sequence to full.
Press [MAGIC].
If needed, press [MEMS] or a channel range button to enter the desired fader
mode. A Magic sequence can only contain all memories or channels, not a
combination of both.
Press the bump buttons corresponding to the memories or channels you want to
include in the sequence. Press a bump again to remove it from the selection.
Once the desired memories or channels have been selected, press [MAGIC] to
randomize the steps of the sequence. You can press [MAGIC] as many times as
needed to achieve the desired look. Each successive press of [MAGIC] creates
new timings based on the settings shown in the LCD window.
SmartFade v1.6 User Manual