Transmitting Ecg Data To The Pc; Transmitting Ecg Data Through The Serial Port - EDAN SE-601A User Manual

SE-601 Series Electrocardiograph User Manual
After setup, press Esc or the function key F5 below
screen.
2. When the main screen1 is displayed, press F2 to switch the gain. Press F4 to set the EMG
filter and the Lowpass filter.
3. Press the START/STOP key to begin to count the sampling time. When the sampling time
reaches 180s, it begins to print an ECG report.
4. It will stop automatically after a complete R-R analysis report is printed, or press the
START/STOP key to stop printing the report.
NOTE: In the R-R mode, you can not set the speed. The constant speed is 25mm/s,
because in the R-R mode, the ECG wave length is compressed to one third of the
original wave length.

7.5 Transmitting ECG Data to the PC

NOTE: To transmit ECG data to the PC, the Smart ECG Viewer software of the
manufacturer must be installed in the PC. You should log into the Smart ECG
Viewer software before transmission.

7.5.1 Transmitting ECG Data through the Serial Port

1. Connect the RS232 socket of the PC to the RS232 socket of the electrocardiograph with an
RS232 cable.
2. Or if the PC has no RS232 socket, connect the USB socket of the PC to the RS232 socket of
the electrocardiograph by using the RS232-USB assembly. For details of the RS232-USB
assembly, please refer to Section 8.2.1, "Transmitting Files Through the Serial Port"
.
SE-601B / SE-601C Lead Setup Window
SE-601A Lead Setup Window
- 50 -
Printing ECG Reports
to exit the System Setup