EDAN SE-601A User Manual page 128

SE-601 Series Electrocardiograph User Manual
Guidance and manufacture's declaration - electromagnetic immunity -
for EQUIPMENT and SYSTEMS that are not LIFE-SUPPORTING
Guidance and manufacture's declaration - electromagnetic immunity
The SE-601 Electrocardiograph is intended for use in the electromagnetic environment
specified below. The customer or the user of SE-601 Electrocardiograph should assure that it
is used in such an environment.
Immunity
IEC 60601 test level
test
Conducted RF 3 V
IEC/EN 150 kHz to 80 MHz
61000-4-6
Radiated RF 3 V/m
IEC/EN 80 MHz to 2.5 GHz
61000-4-3
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
rms
Compliance Electromagnetic environment -
level
Portable
communications equipment should be
used no closer to any part of the
SE-601 Electrocardiograph, including
cables,
3V separation distance calculated from
rms
the
frequency of the transmitter.
Recommended separation distance

1
d
3 V/m

1
d

2
d
Where P is the maximum output
power rating of the transmitter in
watts (W) according to the transmitter
manufacturer
recommended separation distance in
metres (m).
Field
transmitters, as determined by an
electromagnetic site survey,
be less than the compliance level in
each frequency range.
Interference may occur in the vicinity
of
following symbol:
- 121 -
EMC Information
guidance
and mobile
than the recommended
equation applicable
2 .
P
2 . 80 MHz to 800 MHz
P
3 . 800 MHz to 2.5 GHz
P
and
d
strengths from
b
equipment marked
RF
to the
is the
fixed RF
a
should
with the