Refi T And Check Window - Valor 1100JN Installation & Owner's Manual

QUALIFIED
INSTALLER
Refi t and Check Window
1. Place the window in its bottom railing. Ensure to
remove any vermiculite or glass particles in the
railing before installing the window.
2. Push the top of the window frame against the
fi rebox.
Bottom
railing
1
3. While you hold it, pull and hook the side levers back
to the window brackets on each side.
3
62
Installation
4. Apply fi rm hand pressure around the window frame to
ensure the window is sealed tight against the fi rebox.
The window unit must be correctly installed,
fastened and sealed after servicing or serious
bodily injury and/or damage to the appliance
may result.
To ensure a safe operation:
Window
• Double-check that the bottom of the window
frame
frame is correctly installed in the bottom
support railing;
• Verify that the levers are hooked properly to
the window tabs then;
• Pull out the top of the window and release it
2
to insure the springs return it;
• Ensure the window is sealed before operation.
Failure to install the window correctly can
leak carbon monoxide, aff ect the performance
of the fi replace, damage components, cause
overheating resulting in dangerous conditions.
Damage caused by incorrect window installa-
tion is not covered by the Valor warranty.
5. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
Hot Glass Warning Plate
DANGER
!
WARNING
!