Refi T And Check Window - Valor RETROFIRE RF24IDN Installation And Owner's Manual

Place R/H Cross Log
3
Onto Locating Pins
Place L/H Cross Log
Onto Locating Pins
5
Refi t and Check Window
1. Hook the window over the top edge of the fi rebox,
and fasten the bottom two spring-loaded bolts by
pushing in and turning 90 degrees.
IMPORTANT: To ensure a safe operation, verify
that the bolts are hooked properly to the window
tabs; then, pull out the top of the window and
release it to insure the springs return it.
2. After refi tting the window, apply light hand pressure
against the window frame sides to bed-in the
window seal.
3. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
Note: To remove the window, the optional bottom
cover or the cast iron fret, the fret retainers and the
barrier screen will need to be removed fi rst—see
sections Optional Cast Iron Fret Installation or
Optional Bottom Cover Installation.
Installation
L/H Log Locating Pins
4
Check that Window
Moves Freely After
Reinstallation
Spring Loaded
Fastening Studs (2)
Hot Glass Plate
QUALIFIED
INSTALLER
Place Middle Cross Log
Across Gap in Front Log
1/4 Turn
27