Refi T And Check Window - Valor G4 Series Installation & Owner's Manual

QUALIFIED
INSTALLER
Refi t and Check Window
1. Place the window in its bottom railing and push its
top against the fi rebox. Ensure to remove any
particles in the railing before installing the
window.
Window
frame
Bottom
railing
2. While you hold it, hook the side levers into the
window tabs.
3. Pull out the top of the window and release it to
ensure the springs return it.
4. Apply fi rm hand pressure around the window frame
to ensure the window is sealed tight against the
fi rebox.
34
Installation
The window unit must be correctly installed,
fastened and sealed after servicing or serious
bodily injury and/or damage to the appliance
may result.
To ensure a safe operation:
• Double-check that the bottom of the window
frame is correctly installed in the bottom
support railing;
• Verify that the levers are hooked properly to
the window tabs then;
• Pull out the top of the window and release it
to insure the springs return it;
• Ensure the window is sealed before operation.
Failure to install the window correctly can
leak carbon monoxide, aff ect the performance
of the fi replace, damage components, cause
overheating resulting in dangerous conditions.
Damage caused by incorrect window installa-
tion is not covered by the Valor warranty.
5. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated below.
Hot Glass Plate
DANGER
!
WARNING
!