Using The Wall Switch - Valor 1100JN Installation & Owner's Manual

LOW BATTERY INDICATION
CAUTION
DO NOT USE a screwdriver or other metallic object
to remove the batteries from the battery box or the
handset! This could cause a short circuit.
Remote handset: The battery icon
when the battery needs to be replaced.
Replace with one 9 V alkaline battery.
Receiver: Frequent 'beeps' for 3 seconds when the
valve motor turns indicate the batteries need to be
replaced. Replace with four 1.5 V alkaline batteries.
The Wall Switch can be used to
control your fi replace. You can
turn the pilot on or off and you can
increase or decrease the fl ame
height.
Note that the thermostat and
programming functions are not
available with the wall switch.
TO TURN APPLIANCE ON and OFF
• Press ON-OFF button once to light
pilot. Press again to shut of pilot.
Using the Remote Control
HANDSET / RECEIVER MATCH
The remote control handset and receiver are program-
med to function together. In case of a replacement of
the handset or the receiver, you will need to reset the
receiver to allow them to function together. Contact your
dealer for details.
will show

Using the Wall Switch

TO ADJUST FLAME HEIGHT
OWNER'S
INFORMATION
• Press and hold large fl ame
button to gradually increase
fl ame height.
• Press and hold small fl ame
button to gradually decrease
fl ame height.
13