Valor 1100JN Installation & Owner's Manual page 12

OWNER'S
INFORMATION
SETTING P1 OFF TIME
• Briefl y press SET button to scroll
to TIMER
time fl ashes.
• Press
the hour.
• Press
set the minutes.
Timer Programming Example (default temperatures shown)
6:00 a.m.—
P1
Start time
Set temp 74˚F
AUTOMATIC TURN DOWN
• No communication. If there is no communication
between the receiver and the handset for a period of
6 hours, the appliance goes into pilot mode.
• No change in fl ame height. If there is no change
in fl ame height for a period of 6 hours, the appliance
goes into pilot mode.
NOTE: In TEMP or TIMER modes, the fl ame height
will vary according to room temperature. The appli-
ance will continue to work normally. However, if the
room temperature remains the same for 6 hours, the
appliance will go into pilot mode.
12
Using the Remote Control
(moon) while the
P1
(large fl ame) button to set
(small fl ame) button to
8:00 a.m.—
P1
End time
Set temp 40˚F
SETTING P2 ON TIME
• Briefl y press SET to scroll to TIMER mode
(sun) while the time fl ashes.
• Follow the instructions given to set P1 ON time.
SETTING P2 OFF TIME
• Briefl y press SET to scroll to TIMER mode
(moon) while the time fl ashes.
• Follow the instructions given to set P1 OFF time.
Press OFF button to save these settings. The timers
are programmed. See the diagram on programming
sequences on the following page.
Tip
If you want to program only one period, program
and with desired times and program
P1
with the same time as
P2
4:00 p.m.—
P2
Start time
Set temp 74˚F
AUTOMATIC SHUT OFF
• Low batteries in the receiver. With low battery
power in the receiver the system shuts off
completely.
NOTE: This does not apply when the power supply
is interrupted.
• No change in pilot. The appliance shuts off
completely when it is continually in pilot position—
without any change—for a period of 5 days.
P2
.
P1
10:00 p.m.—
6:00 a.m.—
P2
P1
End time
Start time
Set temp 40˚F
P2
P2
P1
and