Install Driftwood Kit 1101Dwk (1100 Models) - Valor 1100JN Installation & Owner's Manual

Install Driftwood Kit 1101DWK (1100 models)

Material required
• Long Beach Driftwood Kit, which contains:
•
3 logs
•
5 pebbles
•
1 x 1.5 lb bag of 3/4" grey/black shale
• Gloves, if desired
Installation
Logs
Carefully unpack the kit.
Each log has pegs to help you locate them on the
ceramic burner platform. Install the logs as shown
below.
1. Place the left log on the left side of the ceramic
burner inserting the two pegs of the log in the holes
of the burner. NOTE: There are two holes for the
front peg of this log depending which type of gas is
used for the appliance.
Natural gas fi re:
Place the log's front
peg in the hole closest
to the center of the
fi rebox for natural gas
fi re. The log covers
both holes.
Propane gas fi re:
Place the log's front
peg in the hole closest
to the left side wall for
propane gas fi res.
Installation
2. Place the right log on the right side of the ceramic
burner inserting the two pegs of the log in the holes
of the burner. The rear end of the log rests on the
pilot shield. NOTE: There are two sets of holes for
this log depending which type of gas is used for the
appliance.
Natural gas fi re:
Place the log's pegs
in the holes closest
to the center of the
fi rebox for natural
gas fi re.
Propane gas fi re:
Place the log's pegs
in the holes closest to
the right side wall for
propane gas fi res.
3. Place the center log inserting its front end peg in
the hole in the front of the burner and resting its rear
end in the slight depression on top of the left log.
QUALIFIED
INSTALLER
55