Download Print this page

Valor 1440 Installation Instructions Manual

H6 series

Advertisement

Available languages

Available languages

Quick Links

DANGER
!
A barrier designed to reduce the risk of burns from the hot
viewing glass is provided with this appliance and shall be
installed for the protection of children and other at-risk
individuals.
The 1440 trim is intended to be used on Valor heaters
models 1400. Mounting of the 1440 does not affect
clearances or other specifi cations listed in the heater
installation manuals—see installation manual supplied
with the heater for more information.
47-5/8" (1209 mm)
1-1/2" (38 mm) between bottom
of appliance and bottom of trim
4005086-02
© Copyright Miles Industries Ltd., 2016
H6 S
1440 Four-sided Trim Kit
Use with Valor 1400 Models only

Installation Instructions

HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
ERIES
Note: Mounting of this trim allows for non-combustible
material up to 3/4" (19 mm) thick installed over top of
the required 1/2" (13 mm) cement board. For thicker
fi nishes, refer to appliance manual.
Linerbox bracket
LH door
Overview
IN STA LLER
Leave this manual
with the appliance.
C ON SUM ER
Retain this manual
for future reference.
1400 engine
Steel front panel
RH door
Plinth
Barrier screen

Advertisement

loading

Summary of Contents for Valor 1440

  • Page 1: Installation Instructions

    The 1440 trim is intended to be used on Valor heaters Note: Mounting of this trim allows for non-combustible models 1400. Mounting of the 1440 does not affect material up to 3/4”...
  • Page 2: Installation

    Installation 3. Place plinth onto supports and push into place with inside edge tucked behind front trim. 1. On completion of fi replace installation, screw the liner bracket to top face of fi rebox with 4 screws. 2. Carefully position and secure steel front panel with 4 low profi...
  • Page 3 Because our policy is one of constant development and improvement, details may vary slightly from those given in this publication. Designed and Manufactured by / for Miles Industries Ltd. 190 – 2255 Dollarton Highway, North Vancouver, B.C., CANADA V7H 3B1 Tel. 604-984-3496 Fax 604-984-0246 www.valorfi replaces.com...
  • Page 4: Directives D'installation

    être installé pour la protection des enfants et des personnes à risques. La Bordure à quatre côtés 1440 est conçue pour Note : L’installation de cette bordure permet un fi ni être installée sur les foyers Valor 1400. L’installation incombustible jusqu’à...
  • Page 5 Installation 3. Placez la plinthe sur les supports de chaque côté et poussez-la en l’insérant dans les attaches des 1. Une fois le foyer installé, fi xez le support de caisse supports. à la face de la caisse avec 4 vis. 2.
  • Page 6 6. Répétez pour l’autre porte. Entretien 7. Installez le pare-étincelles. Les onglets du bas sont AVERTISSEMENT AVERTISSEMENT posés sur le bord de la plinthe et le pare-étincelles NE TOUCHEZ PAS L’ÉCRAN PARE-ÉTINCELLES NE TOUCHEZ PAS L’ÉCRAN PARE-ÉTINCELLES est maintenu en place par des aimants. OU LE FOYER LORSQU’ILS SONT CHAUDS! OU LE FOYER LORSQU’ILS SONT CHAUDS! a.