Refi T And Check Window - Valor PORTRAIT 530INI Installation & Owner's Manual

Refi t and Check Window
1. Place the window centrally against the engine unit and
resting on the support at bottom front of the engine.
2. Pull the clamping bars forward and rotate inwards to
secure the top of the window.
3. Fit the two spring loaded bolts through the bottom of
the window and tighten to secure the bottom of the
window.
4. Pull the top of the window forward and release to
ensure the springs return it in position.
5. Similarly check the bottom of the window by pulling
it forward and releasing.
6. Apply fi rm hand pressure around the window frame
to ensure the window is sealed tight against the
fi rebox.
Installation
The window unit must be correctly installed,
fastened and sealed after servicing or serious
bodily injury and/or damage to the appliance
may result.
To ensure a safe operation:
• Double-check that the bottom of the window
frame is correctly bolted at the bottom;
• Verify that the levers are hooked properly to
the window tabs then;
• Pull out the top and bottom of the window and
release it to insure the springs return it;
• Ensure the window is sealed before operation.
Failure to install the window correctly can
leak carbon monoxide, affect the performance
of the fi replace, damage components, cause
overheating resulting in dangerous conditions.
Damage caused by incorrect window installa-
tion is not covered by the Valor warranty.
7. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
QUALIFIED
INSTALLER
DANGER
!
WARNING
!
Safety warning plate
35