Installation; Unpack Appliance; Convert From Top To Rear Outlet (If Required) - Valor 1100JN Installation & Owner's Manual

QUALIFIED
INSTALLER

Unpack Appliance

Beware of sharp edges! Wear gloves!
1. Remove the cardboard wrapping and the wood
pallet from the appliance and discard.
2. Unpack any loose items from around the appliance.
3. Verify that you have all the components
required for the installation, including:
- approved non combustible cement board;
- liners and fuel bed (in separate cartons);
- trim kit with barrier screen;
- venting components and accessories;
- electrical components if installing optional
blower.
4. The standoff s are supplied fl at on
the fi rebox sides and fi xed at one
end. Swivel up the fl at standoff s,
bend them as shown and fi x the
loose end to the top of the fi rebox.
Standoff s installed
5. Remove the heat shield from the top of the appli-
ance case (3 screws). If using the top outlet or LDK
HeatShift Duct Kit, discard the shield. If using a rear
outlet, keep the shield to reinstall after converting
the top to rear outlet—see next subsection.
Remove heat shield (3 screws)
44

Installation

Convert from Top to Rear Outlet (if required)

This unit is supplied with a top vent outlet which
can be fi eld-converted to a rear vent outlet.
Please note that the rear outlet requires the
installation of the heat shield on top of the heater
case as indicated unless fi tted with optional LDK
HeatShift Duct Kit.
1. Remove the top outlet collar (6 screws).
Standoff
2. Swivel the collar and install as a rear outlet (6 screws).
Fold fl at
3. Reinstall the heat shield to the top of the appliance
standoff s
case (3 screws).
Remove top outlet (6 screws)
Swivel the outlet so
that it is oriented
towards the rear and
reinstall to heater
(6 screws)
Rear outlet with required heat shield
Reinstall heat
shield to top
of appliance
(3 screws)