Refi T And Check Window - Valor LEGEND G3 739JN Installation & Owner's Manual

Refi t and Check Window
1. To refi t the window, place the window against the
fi rebox's opening frame. Make sure that the wider
part of the window frame is at the bottom.
Bottom
of window
(wider frame)
2. While you hold it, push in and turn the two bottom
spring-loaded bolts a quarter turn to engage their pin.
3. Push in the top of the window against the fi rebox and
fasten the two top spring-loaded bolts a quarter turn.
4. Then, pull out the top and bottom of the window and
release it to insure the springs return it.
5. Apply fi rm hand pressure around the window frame
to ensure the window is sealed tight against the
fi rebox.
Installation
The window unit must be correctly installed,
fastened and sealed after servicing or serious
bodily injury and/or damage to the appliance
may result.
To ensure a safe operation:
• Double-check that the bottom of the window
frame is correctly installed in the bottom
support railing/tabs;
• Verify that the bolts are hooked properly to
the window tabs then;
• Pull out the top of the window and release it
to insure the springs return it;
• Ensure the window is sealed before operation.
Failure to install the window correctly can
leak carbon monoxide, affect the performance
of the fi replace, damage components, cause
overheating resulting in dangerous conditions.
Damage caused by incorrect window installa-
tion is not covered by the Valor warranty.
6. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
Hot Glass Plate
QUALIFIED
INSTALLER
DANGER
!
WARNING
!
35