Refi T And Check Window - Valor 1100IN Installation & Owner's Manual

QUALIFIED
INSTALLER
Re t and Check Window
1. To refi t the window, place it in its bottom railing and
push its top against the fi rebox. Ensure there is no
glass or shale particles in the bottom railing.
2. While you hold it, pull the side levers back into the
window brackets on each side.
IMPORTANT: To ensure a safe operation, verify that
the levers are hooked properly to the window tabs;
then, pull out the top of the window and release it to
insure the springs return it.
Also, double-check that the bottom of the window
frame is correctly installed in its the bottom railing.
3. Apply light hand pressure against the window frame
sides to bed-in the window seal.
4. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
Hot Glass Warning Plate
60
Installation
Bottom
railing
Section Views
Window
frame