Valor 1100JN Installation & Owner's Manual page 10

OWNER'S
INFORMATION
•
T E M P
Temperature Mode (Appliance
must be in standby mode; pilot
ignited) - The room temperature
is measured and compared to the
Nighttime Setback temperature.
The fl ame height is then automati-
cally adjusted to achieve the Night-
time Setback Temperature.
•
TIMER
must be in standby mode; pilot
ignited) - The timers P1 and P2
(Program 1, Program 2) each can
be programmed to go ON and OFF
at specifi c times. For instructions
see Timer Programming Mode.
NOTE: The display shows the set temperature every
30 seconds.
CIRCULATING FAN OPERATION
(if equipped)
- Circulating Fan - The circulating fan has 4
speed levels from low (1 bar) to high (4 bars).
• Briefl y press SET button to scroll
to
icons fl ash.
• Press
switch ON and increase fan speed.
• Press
to decrease fan speed. To turn
OFF fan, press
button until all 4 speed level bars
disappear.
NOTE: 8 seconds after the fan has been set, the
handset will automatically go into temperature
control mode. The fan starts 4 minutes after
the gas opens (from OFF or from pilot) at
maximum speed and goes to the displayed
level after 10 seconds. The fan stops 10
minutes after the gas is OFF or at pilot.
10
Using the Remote Control
- Nighttime Setback
- Timer Mode (Appliance
(fan) mode. Fan and Level
(large fl ame) button to
(small fl ame) button
(small fl ame)
SETTING THE ON / OFF TEMPERATURES
SETTING THE "DAYTIME" TEMPERATURE
Default Settings:
TEMP
• Briefl y press SET button to scroll to
TEMP
the SET button until the TEMP
fl ashes.
• Press
to increase the
Temperature.
• Press
to decrease
Temperature.
• Press OFF or simply wait to
complete programming.
Tip
Set the diff erent parameters when they are fl ashing.
(sun), 23ºC / 74ºF
(sun) mode. Hold
TEMP
(large fl ame) button
Daytime Set
(small fl ame) button
Daytime Set