Fieldbus parameterization
4.2
PROFINET IO parameters and monitoring values
The integrated PROFINET IO protocol in the VACON
drive. If the drive is not equipped with the integrated PROFINET IO protocol, the PROFINET IO
menus do not appear, and the protocol cannot be used.
Settings for PROFINET IO can be found under "I/O and Hardware / Ethernet / PROFINET IO". PRO-
FINET IO has two menus, one for parameters and one for monitoring. If the protocol is disabled, the
monitoring menu is not shown on the panel.
Code
Parameter
P5.9.5.1.1
Protocol in use
Communication
P5.9.5.1.2
time-out
P5.9.5.1.3
Name Of Station
Code
Parameter
P5.9.5.2.1
Name of station
Fieldbus protocol
P5.9.5.2.2
status
Communication
P5.9.5.2.3
status
P5.9.5.2.4
Setpoint telegram
Actual value
P5.9.5.2.5
telegram
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
®
Table 5. PROFINET parameters
Min
Max
Unit
0 = Dis-
1 =
-
abled
Enabled
0
65535
s
0
240
chars
Table 6. PROFINET monitoring values
Min
Max
Unit
-
-
-
1
3
-
0
999
-
1
4
-
1
4
-
100 drive must be selected when ordering the
Default
ID
0 = Not in use
1 = PROFINET enabled.
0 = Dis-
2434
The parameter is locked
abled
for editing when the
drive is in RUN state.
0 = The time-out is
10
2435
defined by Master.
(= Watchdog time).
Visible only in VACON ®
Drive spe-
2597
cific
Live. See Chapter 4.2.1.
Default
ID
A value used to uniquely
identify the device on the
network.
This monitoring value is
-
2436
normally not visible but
appears when a
PROFINET IO connection
is established.
1 = Initializing (only
before first connection)
-
2437
2 = Stopped
3 = Operational
4 = Faulted
0-99 Number of
messages with errors.
0
2438
0-999 Number of
messages without
communication errors.
Telegram used in the
setpoint direction.
1 = Vendor-specific 1
1
2439
2 = Vendor-specific 2
3 = Vendor-specific 3
4 = Vendor-specific 4
Telegram used in the
actual value direction.
1 = Vendor-specific 1
1
2440
2 = Vendor-specific 2
3 = Vendor-specific 3
4 = Vendor-specific 4
vacon • 13
Description
Description
4