Installation In Vacon® 100 X; Prepare For Use Through Ethernet - Danfoss VACON 100 industrial Installation Manual

PROFINET IO installation
3.2 Installation in VACON
The AC drive can be connected to fieldbus either through RS485 or Ethernet. The connection for
Ethernet is left to the control terminals.
Ethernet
connection
3.2.1

Prepare for use through Ethernet

Connect the Ethernet cable (see specification in ) to its terminal and run the cable
1
through the conduit plate.
Remount the powerhead.
2
NOTE: When planning the cable runs, remember to keep the distance between
the Ethernet cable and the motor cable at a minimum of 30 cm.
For more detailed information, see the user's manual of the fieldbus you are using.
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
®
100 X
Figure 5.
vacon • 11
11752_uk
3