Navigate To A Waypoint Or Position - Humminbird 1158c Combo Installation And Operation Manual

Program or Edit the waypoint fields: Use the 4-WAY Cursor Control key to move from field to
field, and the UP and DOWN Cursor keys to change values once you are in a field.
In the Waypoint Name, Latitude, and Longitude fields, press the UP and DOWN Cursor keys to
change the letter or number. All upper and lower case letters are available, as well as digits 0-
9 and some punctuation characters.
In the Waypoint Icon field, press the UP and DOWN Cursor keys to change the icon used to
represent the waypoint on the Combo and Chart Views. You can exit these fields with the LEFT
and RIGHT Cursor keys or by pressing the EXIT key.

Navigate to a Waypoint or Position

Navigate to the cursor position: From the Chart View, Side Imaging® View, Chart Combo Views,
or Side Imaging® Combo Views, use the 4-WAY Cursor Control key to move the cursor to a
position or waypoint on the display. Press the GOTO key. Navigation will begin immediately.
Navigate to a specified waypoint: Press the GOTO key. Press the DOWN Cursor key to highlight
a waypoint from the saved waypoints list, and press the RIGHT Cursor key to start navigation.
NOTE: By repeating the previous instructions, you can add more waypoints to create a longer multi-
segment route.
Skip a waypoint: From the Navigation X-Press™ Menu, select Skip Next Waypoint, and press
the RIGHT Cursor key. If there is not another waypoint to skip to, navigation will be cancelled.
Cancel navigation: From the Navigation X-Press™ Menu, select Cancel Navigation, and press
the RIGHT Cursor key. Canceling navigation removes the route and any waypoints created using
the GOTO key, but it does not remove any saved routes from memory. You will be prompted to
save the current route when you cancel navigation.
Introduction to Navigation
116