Waypoints - Humminbird 1158c Combo Installation And Operation Manual

Waypoints allows you to view the Waypoints submenu. See Introduction to Navigation for more
information.
The Waypoints Submenu contains the following menu options:
Create allows you to create a new waypoint, name it, and edit it immediately. The current
boat position will be used as the default, but you can set the coordinates to any valid
position. The icon used to represent the waypoint in the Chart and Combo Views can also
be changed.
Edit allows you to choose from the saved waypoints list, and then edit the Name and
Position (Latitude and Longitude), as well as assign an Icon to represent the waypoint in the
Chart and Combo Views.
Delete allows you to delete a waypoint from the saved waypoints list.
Cursor To allows you to move the cursor quickly to a waypoint from the saved waypoints
list.
Go To allows you to select a waypoint and start navigation toward that waypoint or add that
waypoint to the end of the current route.
Target allows you to apply a target to a waypoint selected from the saved waypoints list.
Grid allows you to apply a trolling grid to a waypoint selected from the saved waypoints list.
NOTE: Only one waypoint can have either a target or a grid applied to it at one time. If you apply a
target or a grid to a new waypoint, the original waypoint will lose its target or grid.
NOTE: The spacing of the rings on the waypoint target and the spacing of the gridlines on the
trolling grid is the same as the length of the scale bar on the left edge of the display. Zooming in or
out will decrease or increase the spacing, respectively.
Navigation Menu Tab

Waypoints

Settings: Create, Edit, Delete, Cursor To, Go To, Target, Grid
176