Controller Display In Boot Mode; Table 11 Display Indications When Controller Is In Boot Mode - Honeywell C300 User Manual

7. C300 Controller Operation
7.4. Control Builder block icon descriptions
Display
Indications
for...
Soft Fail SF
State
See Note 1
Note 1: If a soft failure is detected, the soft failure indication alternates with the
redundancy status indication.

Controller display in BOOT mode

The C300 Controller faceplate display rotates through the following fields when
controller is executing boot firmware:
<Device Index> -> <Controller State>-> <Redundancy Role>
For example:

Table 11 Display indications when controller is in boot mode

Display
Indications
for...
Device Index #nnn
Controller
ALIV/LOAD/
State RDY/FAIL
Fail Code nnnn
Redundancy PRI or nrdn
Role
Note: When the secondary controller is in Boot mode, the controller does not display
BKUP because the controller does not support redundancy in that Controller State.
Similarly, when the secondary controller is in Application mode, the controller does not
display SEC because the BKUP Controller State implies a redundant secondary.
186
Primary Secondary
Controller Controller
SF
#003 -> ALIV -> PRI
Primary Secondary
Controller Controller
#nnn
ALIV/LOAD/
RDY/FAIL
nnnn
SEC
Series 8 C300 Controller User's Guide
Honeywell
Description
Indicates a soft failure condition.
Description
FTE Device Index, where nnn can be 001 to
255. Does not change with redundancy role.
Does not imply redundancy role.
Refer Table 5 and Table 8 for a description
of each controller state indication.
Indicated only when in FAIL, where nnnn =
four digit failure code.
Otherwise Controller State is displayed.
Indicates redundancy role. Refer the note.
R500
April 2017