Interfaces Openvpn <Vtunx> Remote-Port <Port - Brocade Communications Systems 5600 Reference Manual

interfaces openvpn <vtunx> remote-port <port>
Specifies a port on which outgoing sessions are sent.
Syntax
set interfaces openvpn vtunx remote-port port
delete interfaces openvpn vtunx remote-port
show interfaces openvpn vtunx remote-port
Command Default The default port number is 1194.
Parameters vtunx
port
Modes Configuration mode
Configuration
interfaces {
Statement
}
Usage Guidelines Use this command to specify a remote UDP or TCP port on which outgoing sessions are sent. This port
can be used as a client endpoint in a client-server mode tunnel, either endpoint when UDP is used in
site-to-site mode, or the TCP-active endpoint when TCP is used in site-to-site mode. Note that, if
specified, the remote port setting on one endpoint must match the local port setting on the other, and
conversely.
Use the set form of this command to specify a remote UDP or TCP port on which outgoing sessions are
sent.
Use the delete form of this command to remove a remote UDP or TCP port on which outgoing sessions
are sent.
Use the show form of this command to view a remote UDP or TCP port on which outgoing sessions are
sent.
Brocade 5600 vRouter OpenVPN Reference Guide
53-1003719-03
The identifier for the OpenVPN interface. This may be vtun0 to vtunx, where x
is a non-negative integer.
The number of a port on which outgoing sessions are sent. The default port
number is 1194.
openvpn vtunx {
remote-port port
}
interfaces openvpn <vtunx> remote-port <port>
89