Interfaces Openvpn <Vtunx> Local-Address <Ipv4 - Brocade Communications Systems 5600 Reference Manual

interfaces openvpn <vtunx> local-address <ipv4>
interfaces openvpn <vtunx> local-address <ipv4>
Specifies the tunnel IP address on the local end of an OpenVPN tunnel.
Syntax
set interfaces openvpn vtunx local-address ipv4 [ subnet-mask mask ]
delete interfaces openvpn vtunx local-address ipv4 [ subnet-mask ]
show interfaces openvpn vtunx local-address ipv4 [ subnet-mask ]
Parameters vtunx
ipv4
subnet-mask mask
Modes Configuration mode
Configuration
interfaces {
Statement
}
Usage Guidelines Use this command to specify the tunnel IP address on the local end of the OpenVPN tunnel. Only a
single address can be specified. This address is required for site-to-site mode OpenVPN tunnels but not
for client-server mode tunnels. The subnet mask is required only when the interface is configured as a
broadcast interface by using the interfaces openvpn vtunx device-type tap command.
Use the set form of this command to specify the tunnel IP address on the local end of a tunnel.
Use the delete form of this command to remove the tunnel IP address from the local end of a tunnel.
Use the show form of this command to view the tunnel IP address on the local end of a tunnel.
76
The identifier for the OpenVPN interface. This may be vtun0 to vtunx, where x
is a non-negative integer.
Mandatory. An IPv4 address.
A subnet mask for the network associated with the local address. A mask is
required only when
set.
openvpn vtunx {
local-address ipv4 {
subnet-mask mask
}
}
interfaces openvpn <vtunx> device-type tap
Brocade 5600 vRouter OpenVPN Reference Guide
on page 64 is
53-1003719-03