Setting Up The Alarms; Configuring An Alarm - GE moisture.iq User Manual

4.2 Setting Up the Alarms

4.2.1 Configuring an Alarm

Note: An active alarm is indicated by a "Play" symbol, and the alarm selected for editing is highlighted in yellow.
The moisture.IQ features two optional alarms (A and B) for each of its six channels. To configure these alarms,
refer to the menu map in Figure 77 on page 110 and tap the Alarms button on the right side of the main touch
screen to open a screen similar to that shown in Figure 47 below.
1. Tab the button for the desired Channel (1-6) and Alarm ( A or B ).
2. In the Measurement Selection section, tap the Mode, Unit and Type ( In Band , Out Band or Setpoint )
buttons to enter the desired settings for the alarm. (For available modes and units, refer to Table 8 on
page 61.)
3. Tap the Upper text box and enter the upper value via the keypad. Repeat this procedure for the Lower
value.
moisture.IQ User's Manual
Figure 47: Alarm Selection Screen
Chapter 4. Using the Outputs, Alarms and Logger Menus
53