Chapter 1. Installation; Introduction; Unpacking The Moisture.iq; Installing The Moisture.iq - GE moisture.iq User Manual

Chapter 1. Installation

1.1 Introduction

Users typically install the moisture.IQ as part of a complex process system, which includes components such as
filters, pumps, and pressure regulators. In such an environment, probes and other parts of the system may be
subjected to environmental hazards, such as high temperature, pressure extremes, corrosive elements and
mechanical vibrations.
This section contains information and instructions for installing the moisture.IQ into a process system, while
taking into account all of the above factors. The following section describes how to set up and connect the
moisture.IQ.
If you have questions about the installation procedures, contact our technical support department. See the rear
cover of this manual for contact information.

1.2 Unpacking the moisture.IQ

Before beginning the installation, unpack the unit and make sure all the parts and documentation listed on the
packing slip are included. Be sure to inspect each piece of equipment, including the sample system, for
evidence of mishandling. If anything has been damaged or is missing, report this to the carrier and to BHGE
immediately.

1.3 Installing the moisture.IQ

To install the moisture.IQ, refer to the drawing for your specific configuration (benchtop, rack mount, panel
mount, weatherproof or explosion-proof) in the Certification and Safety Statements at the end of this manual.
WARNING! To ensure the safe operation of this unit, you must install and operate the moisture.IQ as
described in this user's manual. In addition, be sure to follow all applicable safety codes and regulations
for installing electrical equipment in your area.
WARNING! For Zone 2 Stainless Steel: Do not rub front face with a dry cloth within the hazardous
area as a spark may occur.
moisture.IQ User's Manual
Chapter 1. Installation
1