Chapter 4. Using the Outputs, Alarms and Logger Menus
4.2.2 Testing the Selected Alarm
Complete the following steps to test the alarm:
1. Tap the Channel (1-6) and Alarm ( A or B ) to be tested, and then tap the Test button to open a screen
similar to Figure 48 below.
2. Tap the Trip button to trip the alarm and verify that the alarm has been tripped.
3. Tap the Reset button to reset the alarm and verify that the alarm has been reset.
4. After you have finished testing the alarm, tap the Exit button to return to the Alarm Selection screen.
54
Figure 48: Alarm Test Screen
moisture.IQ User's Manual