Setting The Probe Auto-Cal Schedule - GE moisture.iq User Manual

5.1.4 Setting the Probe Auto-Cal Schedule

To set the frequency with which the probe Auto-Cal function is run, proceed as follows:
1. From the Probe Configuration screen, tap Auto-Cal Setup button to access the Set Auto-Cal Interval
screen for the desired probe (see Figure 57 below).
2. Enter the desired number of hours (1 - 730) between Auto-Cal runs.
3. Tap the Save button to enter the new value into the moisture.IQ, or tap the Cancel button to retain the
previous value.
moisture.IQ User's Manual
Figure 57: Set Auto-Cal Interval Screen
Chapter 5. Using the Configuration Menu
65