Chapter 8. Troubleshooting; Screen Messages - GE moisture.iq User Manual

Chapter 8. Troubleshooting

The moisture.IQ is designed to be maintenance and trouble free; however, because of process conditions and
other factors, minor problems may occur. Some of the most common problems and procedures are discussed
in this section. If you cannot find the information you need in this section, please consult BHGE.
WARNING! Do not attempt to troubleshoot the moisture.IQ beyond the instructions in this section. If
you do, you may damage the unit and void the warranty.
This chapter covers the following topics:
•
Screen Messages (see "Screen Messages" below)
•
Common Problems (see "Common Problems" on page 96)

8.1 Screen Messages

The moisture.IQ has several screen messages that may display during operation. Refer to Table 11 below for
a list of these messages and the possible causes.
Screen Message
CHANNEL NOT
AVAILABLE
NO PROBE
NOT AVAILABLE
moisture.IQ User's Manual
Table 11: Screen Messages and the Possible Causes
Possible Cause
Module not installed
Unit has not been
configured for the probe
activated. For
example, you cannot
display
pressure on a channel
where only an M Series
probe is
configured.
The mode and/or units
selected require more data
or need a
different probe. For
example, you cannot read
%RH with a
moisture probe that does
not have the temperature
option.
System Response
None
None
None
Chapter 8. Troubleshooting
Action
Select a different channel.
Make sure the correct probe is
activated as described on page 60.
Connect the required probe.
Choose a different mode and/or
units as described on page 60.
Connect the required probe.
93