Introduction; Setting Up The Alarms - GE Moisture monitor series 3 Programming Manual

Introduction

Setting Up the Alarms

Advanced Programming
Now that the MMS-3 is running and the screen is set up, you may
want to use the other operational features included in this chapter (see
the previous page for the list and locations of those features).
The MMS-3 can be equipped with an optional high and low alarm
relay for each channel.
Press the [PROG] key to enter the user program.
Enter Passcode: XXXX
Note: If you have already entered the user program, see Figure 3-3
on page 3-49 to navigate to the Alarms Menu.
Programming Menu
[ALARMS]
Be sure the number displayed in the upper right-hand corner of the
screen is the channel you want to program. If not, press the [CHAN]
key to select the desired channel.
Select Alarm
[A] B
The MMS-3 briefly flashes a message, "Relay Status -- Reset," and
then displays the next prompt.
Select Mode
O [H] T P
Enter the passcode.
1
Use the arrow keys to move the
brackets to ALARMS and press
[YES].
1 Use the arrow keys to move the
brackets to the desired alarm
(A or B) and press
1
Use the arrow keys to move to
the desired measurement mode
Aux1
[YES]
and press
page 3-2 for a list of available
measurement modes.
March 2008
[YES]
.
. See Table 3-1 on
3-1