GE moisture.iq User Manual page 69

4.3 Setting Up and Running Logs (cont.)
•
Create Log button:
a. Tap the Create Log button to open the Log Creator screen, as shown in Figure 51 below.
b. Enter the Log File Name , the Start Time , the End Time , the Separator ( Comma or Tab ), the Log Type
( Normal , Cyclic or Error ) and the Logging Interval (in minutes:seconds ).
c. Tap the Log Data button at the upper right corner of the Log Creator screen to open the Log Data
screen.
d. Highlight one of the 16 log measurement boxes and use the buttons at the top of the screen to
specify the Channel , Mode and Unit for that measurement.
e. After you have finished configuring your log data, tap the Return button to return to the Log Creator
screen above. Then, tap the Return button again to return to the Logger Setup screen.
f. When you are ready, tap the Start button to begin running the new log.
moisture.IQ User's Manual
Figure 51: Log Creator Screen
Chapter 4. Using the Outputs, Alarms and Logger Menus
57