Initial Setup - GE moisture.iq User Manual

Chapter 2. Operation
2.4 The Data Element Editor (cont.)
As shown in Figure 29 on page 32, the following settings are available for the display:
•
Channel: Select the channel (1-6) to be displayed.
•
Mode: Select the measurement type (Hygro, Pressure, Temperature, Oxygen, Aux 1, Aux 2 or Function)
to be displayed.
•
Unit: Select the units of measure to be displayed.
•
123/Graph: Toggle between a Numeric and Graphical display.
Note: The error message is only available in numeric mode — not in graphical mode.
•
12.23/1.2E5: Toggle between Floating Point Decimal and Scientific numeric displays.
•
Slider Bar: Use the Left and Right arrows to select the number of decimal places for the numeric display.
•
Copy and Paste: Use these buttons to duplicate display settings from one measurement display to
another.
•
Clear All: Use this button reset the display to the default state.
Note: The current selection for the toggled items is highlighted in blue.
As with all of the moisture.IQ programming screens, tap the Check button
tap the Cancel button

2.5 Initial Setup

Before you can obtain accurate measurement data, you must properly configure the moisture.IQ and all
attached probes. This is accomplished by using the Main Menu options along the right side of the measurement
display screen. Simply tap the desired menu item on the touch screen to access that particular menu, and
proceed to the appropriate chapter in this manual for detailed instructions.
After your initial setup is complete, these same menus can be used to program the moisture.IQ with your
personal preferences and to reconfigure the unit whenever there are any changes in your system.
Note: Initially, all menus are locked at startup. After you enter a password, these menus will be unlocked, but
will timeout (and relock) after 15 minutes with no activity.
34
to keep the previous settings.
to save your new settings, or
moisture.IQ User's Manual