4
Instrument Setup
4.8
Electrical connection
Warning
The instrument must be connected to a grounded mains socket.
Of the
set of power cords
supply (plug must fit on-site wall outlet).
Connecting to mains
L The electrical connenctions are located at the back panel of the instrument
1. Make sure the printer is switched OFF, mains switch
2. Insert the correct power cord into the mains input socket
3. Switch on mains switch (switch to position "I" = ON).
2
Fig. 32
Note
Once switched on for the first time, the mains switch
"I" = ON.
Setting up the data connection
L To use the printer, a serial data cable
delivery).
1. Connect the cable to printer port
2. Connect the cable to one of the serial ports
control software.
40
supplied, be sure to use only the one that is appropriate for the local power
1
(→ "Fig.
(→ "Fig. 32-3")
(→ "Fig.
3
4
(→ "Fig. 32-3")
(→ "Fig. 33")
is required
32-1").
(COM
2) of the computer containing the
1,
COM
(→ "Fig.
32").
in position "0" = OFF.
32-4").
should always remain in position
(→ p. 29 – 4.3 Standard
Version 2.0, Revision I