Removing The Used Ink Cartridge; Inserting The New Ink Cartridge; Removing The Protective Cap - Leica IP C Instructions For Use Manual

6.3.1 Removing the used ink cartridge

1. Open the cover plate
corner (→ "Fig.
2. Close the red cap
3. Press the red retaining bracket
(→ "Fig. 57-2")
4. Retighten the red cap and completely remove the cartridge from the printer.
5. Then remove the ink cartridge and store the ink cartridge in a horizontal position in a sealed
container.
6. Dispose the used ink cartridge in accordance with the regulations of your laboratory and your
legislative.
1
Fig. 57

6.3.2 Inserting the new ink cartridge

1. Take a new ink cartridge from the carton and remove the plastic packaging.
2. Carefully shake the ink cartridge 2 to 3 times.
3. Pull the red retaining bracket forward and insert a new ink cartridge about halfway into the
slot.
4. Follow the information on the flag attached to the ink cartridge.
5. Open the red protective cap
6. Fully insert the ink cartridge into the slot.

6.3.3 Removing the protective cap

1. Unscrew the red protective cap all the way, remove the information flag and place the red
protective cap in the recess provided on the ink cartridge
2. Upon completion, make sure that the red retaining bracket is in the correct position
(→ "Fig. 41-1")
Note
Never press the
3. On the control panel press
Leica IP C
(→ "Fig. 34-2")
34").
(→ "Fig. 39-3") and loosen it again with one full turn.
(→ "Fig. 57-1")
approx. 30 mm until the INK EMPTY LED
4
(→ "Fig. 39-3")
and close the cover plate.
CLEAN button while a new or used ink cartridge is in the instrument!
LOADED
Cleaning and Maintenance
on the left side of the instrument by pressing its top left
down and pull the ink cartridge out
(→ "Fig. 57-3")
3
2
one turn counterclockwise.
(→ "Fig.
88 is displayed on the control panel.
(→ "Fig. 42-5").
lights up.
57-4").
6
67