Fig. 33
Connecting a remote alarm device
L If required, connect the external alarm system (optional) to jack
1. The remote alarm device is connected to the printer via a 3.5 mm-diameter jack connector.
2. For details about the remote alarm see
Warning
Any device that is connected to any one of the instrument interfaces must satisfy the requirements
for SELV circuits.
4.9
Exchanging the transport cartridge for an ink cartridge
In the factory condition,
able to print, the
delivery). To do so, proceed as follows:
1. Open the cover plate
corner).
2. Loosen
the red cap
switch on the printer using the main switch on the rear side
initialize.
Leica IP C
the printer is supplied with a
transport cartridge
must be exchanged for an ink cartridge
(→ "Fig. 34-2")
(→ "Fig. 34-4")
(→ p. 56 – 5.3 Alarm
transport cartridge
on the left side of the instrument (pressing its top left
of the
transport cartridge
Instrument Setup
(→ "Fig.
33-2").
functions).
(→ "Fig. 34-3")
inserted. To be
(→ p. 29 – 4.3 Standard
(→ "Fig. 34-3")
by one turn, then
(→ "Fig. 32-3")
and wait for it to
4
41