Leica IP C Instructions For Use Manual page 39

Note
When filling the magazines
• If taped cassettes are used, make sure the newly inserted stack aligns perfectly with the previously
loaded cassettes
Note
IMPORTANT! Always pull off the adhesive strip
can arise between the cassettes.
Depending on the type of cassettes, each magazine holds up to 80 cassettes. If cassette sizes other
than those specified in the table on
use trial and error to find out which insert is required in the magazine.
Caution
Important!
Only the cassette sizes listed in the table on
been tested with the Leica IP C.
Leica does not guarantee that cassette types other than those tested can be processed in the
instrument.
1. Insert a filled magazine
the slot.
2. Tilt the magazine backwards as far as it will go, then firmly push the magazine downwards.
Guide rail
3. Keep following this procedure until the printer is completely filled with magazines; observe the
correct sequence while doing so.
Fig. 31
Leica IP C
ensure no gaps are present
(→ "Fig. 30").
(→ p. 37 – Filling and inserting the magazines)
(→ "Fig. 31-2")
(→ "Fig. 31-3") must lock into holder
2
1
between the cassettes.
(→ "Fig. 31-1") from top to bottom, so that no gaps
(→ p. 37 – Filling and inserting the magazines)
into the printer as shown and insert it into the holder at
(→ "Fig. 31-4").
3
Instrument Setup
are to be used,
have
4
4
39