Table of Contents
Advertisement
Warning
Do not reinstall a used transport plate
head.
To prevent damage to the print head, always use the red
printing.
Fig. 36
6. Push the small lever
7. Press any key of the control panel
printer ready to operate.
Caution
If no key is pressed, the print head will close automatically 150 seconds after opening to prevent it
from drying out. An acoustic signal (5 beeps) will sound after 120 seconds, after which the final 30
seconds will be counted down on the display
Fig. 37
8. Press the red retaining bracket
transport cartridge can be removed.
9. Pull the transport cartridge
EMPTY LED
10. Retighten the red cap
11. Release the red retaining bracket.
Leica IP C
(→ "Fig.
2
(→ "Fig. 35-1")
(→ "Fig. 37-1")
1
(→ "Fig. 38-1")
(→ "Fig. 38-4")
lights up
(→ "Fig. 38-2").
(→ "Fig. 38-3")
36-2"), as it will no longer completely seal the print
replacement plate
back down into its original position.
to reposition the print head and make the
(→ "Fig.
37-2").
2
down and and hold it in this position, so that the
approx. 30 mm out of the instrument until the
and then remove the cartridge completely
Instrument Setup
(→ "Fig. 36-1")
when
1
(→ "Fig. 38-5").
4
INK
43
Hide quick links:
Advertisement
Table of Contents
