Electrical Connection - Leica IP S Operating Instructions Manual

4.8 Electrical connection

The instrument MUST be connected to a grounded mains socket.
Of the set of power cords supplied, only use the one that is appropriate for the local
power supply (plug must fit wall outlet on site).
Back panel of instrument -
electrical connections
56
55
Setting up the data connection
• To use the printer, a serial data cable is re-
quired (part of standard delivery).
Fig. 20
• Connect the cable to one of the serial ports
(COM 1, COM 2) of the computer running the
control software.
Leica IP S
Connecting to mains
• Make sure the printer is OFF - mains switch
• Insert the correct power cord into the mains
53
• Switch on mains switch (switch to position
54
Fig. 19
Connecting a remote alarm device
• If required, connect the external alarm system
• The remote alarm device is connected to the
• Connect the
cable to port
(55) at the
printer.
• For details about the remote alarm see
(53) in position "0" = OFF.
power connecting socket (54).
"I"= ON).
Once switched on for the first time,
the mains switch (53) should always
remain in position "I" = ON .
(optional) to jack (56).
printer via a 3.5 mm-diameter jack connector
(optional accessory).
ter 5.3.
Any device that is connected to any
one of the instrument interfaces
must have been tested in accor-
dance with EN 60950 and must sat-
isfy the requirements for SELV cir-
cuits.
4. Setup
chap-
25