IDEC FC6A-C16K1CE Communications Manual page 81

Designating Data Register as S1
When a data register is designated as source device S1, conversion type and transmit digits must also be assigned. The data
stored in the designated data register is converted and the assigned quantity of digits of the resultant data is transmitted. The
conversion types that are available are: Binary to ASCII, BCD to ASCII, and no conversion.
When repeat is designated, data of data registers as many as the repeat cycles are transmitted, starting with the designated data
register. Repeat cycles can be up to 99.
Conversion Type
The transmit data is converted according to the designated conversion type as described below:
Example: D10 stores 000Ch (12)
(1) Binary to ASCII conversion
000Ch
D10
(2) BCD to ASCII conversion
000Ch
D10
(3) No conversion
000Ch
D10
Transmit Digits (Bytes)
After conversion, the transmit data is taken out in specified digits. Possible digits depend on the selected conversion type.
Example: D10 stores 010Ch (268)
(1) Binary to ASCII conversion, Transmit digits = 2
D10 010Ch
(2) BCD to ASCII conversion, Transmit digits = 3
010Ch
D10
(3) No conversion, Transmit digits = 1
D10 010Ch
Binary to ASCII conversion
Decimal value
No conversion
When transmitting 2 digits
Binary to ASCII conversion
00268
Decimal BCD to ASCII
value
No conversion
FC6A S M S A
ERIES ICRO MART LL
5: U
ASCII Data
"0" "0" "0" "C"
(30h) (30h) (30h) (43h)
When transmitting 4 digits
00012
BCD to ASCII conversion
ASCII Data
NUL FF
(00h) (0Ch)
ASCII Data
"0" "1" "0" "C"
(30h) (31h) (30h) (43h)
ASCII Data
"0" "0"
(30h) (30h) (32h)
conversion
ASCII Data
SOH FF
(01h) (0Ch)
- -O T C
IN NE YPE OMMUNICATION
C
SER OMMUNICATION
"0" "0"
(30h) (30h)
When transmitting 5 digits
Transmitted Data
Lowest 2 digits
"2" "6" "8"
(36h) (38h)
Transmitted Data
FF
(0Ch)
Lowest 1 digit
M FC9Y-B1730
ANUAL
I
NSTRUCTIONS
ASCII Data
"0" "1" "2"
(30h) (31h) (32h)
"0" "C"
(30h) (43h)
Transmitted Data
"2" "6" "8"
(32h) (36h) (38h)
5-5