IDEC FC6A-C16K1CE Communications Manual page 206

10: S E- F
END MAIL UNCTION
Download the user program to the FC6A Series MicroSmart.
5.
This concludes configuring the e-mail settings.
■ General Settings
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(1) SMTP Server
Specify the IP address or the host name of the sending e-mail server that is used to send e-mails. A maximum of 40 ASCII
characters can be entered.
(2) SMTP Server Port
Specify the port number of the sending e-mail server. Normally, SMTP uses port 25, SMTP-AUTH uses port 587, and SMTPs uses
port 465.
(3) Sender E-mail Address
Specify the e-mail address that is included in the sender field of the e-mails to be sent from the FC6A Series MicroSmart. A
maximum of 40 ASCII characters can be entered.
(4) Sender Name
Specify the name that is included in the sender field of the e-mails to be sent from the FC6A Series MicroSmart. A maximum of
40 ASCII characters can be entered.
(5) Use secure connection (SSL)
When SSL communication is required with the sending e-mail server that is used, select this check box.
Notes:
When specifying the SMTP server with an IP address, 0 in the high order digits of the values is ignored. For example, when the IP address
•
"192.168.1.234" and "192.168.001.234" are considered as the same IP address.
When specifying the SMTP server with an SMTP server name, the host name of the SMTP server must be resolved using DNS. For DNS and
•
DNS server settings, see "Network Settings" on page 3-3.
Configuration Example: The sender e-mail address and sender name are grouped and shown in the sender field of the e-mail.
If the sender e-mail address is test@sample.com and the sender name is Test Mail, the text shown in the sender field will be as
follows:
Test Mail <test@sample.com>
10-4 FC6A S M S A
ERIES ICRO MART LL
- -O T C
IN NE YPE OMMUNICATION
M FC9Y-B1730
ANUAL